Symmons W-600 Manuel d'instructions

Naviguer en ligne ou télécharger Manuel d'instructions pour Non Symmons W-600. Symmons W-600 Instructions / Assembly Manuel d'utilisatio

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 4
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 0
2. Sweat 5" length of
1
/
2
" copper tubing (not provided) into union ells. (When stops are used, use 3
1
/
2
" length
of copper tubing and sweat into female end of stop-sweat male end of stop into union ells.) Slide rubber
washers (not required when stops are used) onto copper tubing and mount thru sides of box and secure
elbows to box with
3
/
4
" long pan head self tapping screws. Slide rubber washers against inside of box.
Connect supplies from above or below, hot on left, cold on right. DO NOT SWEAT SOLDER CONNEC-
TIONS CLOSE TO BOX.
3. Mount valve handle onto valve and mount valve to union ells with gaskets and screws provided.
in-wall washing machine
supply and drain xture
INSTALLATION PROCEDURE:
INSTALL BETWEEN 2" x 4" STUDS ON 16" CENTERS OR OTHER
CONSTRUCTION EQUIVALENT – ACTUAL MEASUREMENT OF STUDS 1
1
/
2
" X 3
1
/
2
"
1. Mount angle straps to box as shown with (4)
1
/
2
" long pan head sheet metal screws. (Use stubby screw-
driver.) Use hole “A” for
1
/
2
" thick nished wall, hole “B” for
3
/
4
" thick nished wall. Mount assembly
between studs taking care to mount square.
Laundry-Mate™
Vue de la page 0
1 2 3 4

Résumé du contenu

Page 1 - Laundry-Mate™

2. Sweat 5" length of 1/2" copper tubing (not provided) into union ells. (When stops are used, use 31/2" length of copper tubing and sw

Page 2 - Limited Warranty

4A. Completenishwall—frontedgeofboxmustbeushwithnishwall.4B. Whenservicestopsareused,llareaaround stops and slots in box with

Page 3

Accesorio de abasto y drenaje empotrado en la pared para lavadoras de ropaPROCEDIMIENTO DE INSTALACIÓN:INSTALE EL ACCESORIO ENTRE DOS MONTANTES VERTIC

Page 4 - ■ ZV-2 ■ 050208

4A. En paredes terminadas - el frente de la caja debe quedar al ras con la pared terminada.4B. Al usar válvulas de paso de servicio, rellene el área

Commentaires sur ces manuels

Pas de commentaire